Phones & PBX
Jump to navigation
Jump to search
Bay Area Mesh Phone Exchange (BAMphone)
The Bay Area Mesh's Phone Exchange, called BAMphone.
Wireless Mesh Emergency Telephone System (WiMETS)
DEPRECIATED :-(
MESH Phone
The following was compiled by Mark N2MH. The original (and up to date) version can be found here.
N2MH has also provided links to his documentation .
Phones
The following table summarizes phones that various hams have successfully used on the Mesh.
Model | POE * | Local Power | Web Interface | tftp | Comments | |||||
---|---|---|---|---|---|---|---|---|---|---|
Cisco | http://www.cisco.com | |||||||||
7940 | Yes | 48V DC | Partial | Required | 2 lines; need to load SIP; see N4SV comments | |||||
7961 | Yes | 48V DC | Partial | Required | Up to 6 lines; need to load SIP; see N4SV comments | |||||
Grandstream | Setup Instructions | http://www.grandstream.com | ||||||||
GXP-1450 | No | 5V DC | Yes | Yes | 2 lines | |||||
GXP-1620/GXP-1625 | 1625 only | 5V DC | Yes | Firmware updates
also via http or https |
2 lines; Both models are the same phone - only 1625 supports POE | |||||
GXP-2000 | Yes | 5V DC | Yes | Yes | Up to 4 lines | |||||
GXP-2140 | Yes | 12V DC | yes | yes | Up to 4 lines; | |||||
GXP-2160 | Yes | 12V DC | yes | yes | Up to 6 lines; has extra speed dial buttons programmable through the web interface. | |||||
GXP-2200 | Yes | 12V DC | Yes | Yes | Similar to 2160; no extra speed dial buttons; nice video phone with Android but no built-in camera (ie, receive only) | |||||
GXV3240 | Yes | Yes |
|
|||||||
GXV3275 | Yes | Yes |
|
|||||||
HT503 | No | 12V DC | Yes | ? | 2-port ATA 1-FXO 1-FXS | |||||
HT701 | No | 12V DC | Yes | ? | 1-Port ATA FXS | |||||
DP715/DP710 | No | Base: 6v wall wart
Portable: 2 rech. AAA batteries |
Yes | Yes |
|
|||||
Linksys
(now Cisco) |
||||||||||
SPA503G | 5V DC | Yes | 3 Lines | |||||||
SPA504G | Yes | 5V DC | Yes |
|
||||||
SPA941 | No | 5V DC | Yes |
|
||||||
Nortel | ||||||||||
1535 | No | 12V DC | No | ? |
|
|||||
Obihai | http://www.obihai.com | |||||||||
Obi1062 | Yes | 12V DC | Yes | ? | See W7REJ comments below | |||||
Polycom | http://www.polycom.com | |||||||||
SoundPoint 32x | Yes | 24V DC | Yes | Yes | 2 lines | |||||
SoundPoint 33x | Yes | 24V DC | Yes | Yes | 2 lines | |||||
SoundStation IP 5000 | Yes | POE only | Yes | ftp | 1 line; local power via POE injector only | |||||
VVX410 | Yes | Yes | Yes | Yes | 2 lines | |||||
SNOM | http://www.snom.com | |||||||||
300 | 5V DC | Yes | ||||||||
Yealink | http://www.yealink.com | |||||||||
W60B | Yes | PoE only | Yes | ? | Setup Instructions |
|
||||
SIP-T22P | Yes | 5V DC | Yes | Yes |
|
|||||
SIP-T54W | Yes | 5V DC | Yes | Yes |
|
* POE here means managed 48 Volt POE (IEEE 802.3), such as obtained from an ethernet switch. It does not mean passive 12/24V power as used by a Ubiquiti node or an external 12V power supply.